BL604E SDIO firmware board

nandojve

Hello,

I have a BL604E SDIO board and would like use it as a Linux WiFi device by SDIO port. I can compile Linux firmware from bl602_sdio_driver. However, to Linux recognize the board I assume that there should be a minimal Device Firmware flashed at BL604 device. if this assumption is correct, where can I find the minimal Device firmware to build and flash for BL602/604?

robert

nandojve , This is probably too late to help, but I recently stumbled across https://github.com/bouffalolab/bl602_sdio_driver

I've never used it and there's not a lot of doc, but I hope that helps.

rodger2206

nandojve
I have the following suggestions:

Insert and remove the BL604E SDIO board to see whether the mainboard can identify the card
If the BL604E SDIO board is recognized, you compile the BL602_sdio_driver, https://github.com/bouffalolab/bl602_sdio_driver
The burned firmware is in the FW under directory bl602_sdio_driver, The detailed operation is described in readme
I hope it's helpful

nandojve

Hello, I was wondering if someone have time to check this one.

rodger2206

I have the following suggestions:

Insert and remove the BL604E SDIO board to see whether the mainboard can identify the card
If the BL604E SDIO board is recognized, you compile the BL602_sdio_driver, https://github.com/bouffalolab/bl602_sdio_driver
The burned firmware is in the FW under directory bl602_sdio_driver, The detailed operation is described in readme

I hope it's helpful